Cost guide
What It Costs to Clean, Re-Sand and Seal Pavers in Florida
As of October 2026, cleaning, re-sanding and sealing an existing paver surface in Florida runs $1.50–$3.25 per square foot, with most jobs landing nearer $1.75–$2.75. An 800 square foot driveway or patio falls between about $1,200 and $2,600 before any releveling. We quote the combined service by scope across Greater Orlando and Sarasota–Manatee.
By the Opera Concrete & Pavers estimating team · Updated October 1, 2026
Get a free estimate
Tell us about the project and we'll call to set up a free site visit.
How much does it cost to seal pavers?
Cleaning, re-sanding and sealing an existing paver surface in Florida runs $1.50–$3.25 per square foot as of October 2026, with most jobs landing nearer $1.75–$2.75, including pressure washing and re-sanding as part of the visit (HomeGuide). A Central Florida contractor's own 2026 pricing lines up closely: $1.50 to $3.00 per square foot, with most homeowners paying $750 to $2,500 for a 500 to 1,000 square foot surface (Castle Clean & Seal, Central Florida). Pressure washing alone, without re-sanding or a sealer coat, costs far less, $0.35 to $0.80 per square foot (HomeGuide). What a specific job costs depends on how much joint sand has washed out, whether any pavers have sunk and need releveling first, and which sealer finish is specified.
Is sealing pavers worth the money?
For most driveways, patios and pool decks, yes, measured against what it costs to let the surface go instead. The paver industry's own construction standard treats sealing as optional, not a requirement for the pavers to perform structurally, but it locks compacted joint sand in place and slows staining and UV fading. Skipping it doesn't cost nothing; a joint that loses its sand is what lets a paver rock loose and eventually sink, and fixing that runs far more than a sealing visit would have. Paver releveling and repair, priced by scope rather than a flat sealing rate, costs $7 to $30 per square foot nationally, and replacing a few individual sunken stones runs $8 to $20 per square foot (Angi). Against a $1.50 to $3.25 per square foot sealing visit every few years, catching a joint before it fails is the cheaper path more often than not.
Paver sealing cost by scope
"Sealing" covers a few different jobs depending on what the surface actually needs.
| Scope | Range per sq ft | Note |
|---|---|---|
| Pressure washing only | $0.35–$0.80 | No re-sanding or sealer coat |
| Clean, re-sand and seal (standard visit) | $1.50–$3.25 | Our combined-service range |
| Releveling a sunken or rocking section | $6–$12 for large areas; $8–$20 per stone | Priced on top of the cleaning and sealing visit, not instead of it |
HomeGuide, sealing and pressure washing; releveling figures from HomeGuide, driveway repair and Angi.
Paver sealing cost by surface size
Central Florida pricing scales roughly in proportion to area, with driveways, pool decks and patios each carrying a slightly different rate depending on exposure and access (Castle Clean & Seal).
| Surface | Typical range per sq ft | Example total |
|---|---|---|
| Driveway | $1.50–$2.50 | $900–$3,000 for 600 sq ft |
| Pool deck | $1.75–$3.00 | $1,400–$2,400 for 800 sq ft |
| Patio | $1.50–$2.95 (sized job) | $450–$2,000 |
Does sealing cost differ around Orlando and Sarasota–Manatee?
The Central Florida contractor pricing above is the only Florida-specific regional data found for paver sealing, and it covers the counties in our Orlando unit. A South Florida contractor quotes a noticeably lower starting rate, $0.75 to $1.50 per square foot, but that figure comes from a market well outside our Sarasota–Manatee service area and shouldn't be read as a Suncoast price (Craft Pavers). No published cost guide breaks out sealing pricing for Sarasota or Manatee specifically. We quote cleaning, re-sanding and sealing the same way on both coasts, priced by the surface's condition and size rather than by which county it's in.
What moves a sealing quote up or down
A per-square-foot range hides the details that separate a quick visit from a longer one.
| Factor | Why it matters | Typical effect |
|---|---|---|
| Algae, moss or heavy staining | More passes with the pressure washer before sand or sealer go down | Pushes a job toward the top of the range |
| Sand type | Polymeric sand costs more material than dry sand | Higher upfront cost, fewer repeat visits for washout |
| Surface type | Pool decks see chlorine, splash and sun exposure patios don't | Pool decks run $1.75–$3.00/sq ft against $1.50–$2.50 for driveways in Central FL data |
| Releveling | A sunken or rocking paver needs the base rebuilt before anything else happens | Adds $6–$20 per sq ft or per stone on top of the base sealing price |
| Minimum job fee | Small areas don't scale down proportionally | A South Florida contractor sets a $1,000 minimum regardless of square footage (Craft Pavers) |
Ranges drawn from the Florida sources cited on this page.
Two sealing budgets, worked through
Say you have a 600 square foot paver driveway and walkway in a 2000s subdivision near Kissimmee that hasn't been resealed in about five years and has a few joints losing sand near the garage apron. At the Central Florida driveway rate, that runs roughly $900 to $1,500 for cleaning, re-sanding and sealing, with no releveling needed if the apron is still flat.
Say instead you have an 800 square foot pool deck in a 1990s community near Bradenton with chlorine staining and two or three pavers that have sunk slightly near the skimmer. The sealing itself runs roughly $1,400 to $2,400 at the pool-deck rate, plus a separate releveling charge for the sunken units, likely $50 to $150 for a small handful of individual stones rather than a full-field rebuild. In both cases, a quote that itemizes the releveling separately from the clean-and-seal price is easier to compare against a competing bid than one lump total.
Getting more sealing life for the money
The surface itself, not a calendar date, should set when the next visit happens, but there are ways to keep each visit's cost down:
- Bundle a driveway, patio and walkway into one visit rather than scheduling them separately; one mobilization and one minimum fee cover all three.
- Schedule for a dry stretch rather than racing a forecast; sealing a surface that's still damp underneath often means redoing the work.
- Keep up light routine sweeping and the occasional rinse between visits, since windblown grit and standing algae are what push a job toward the top of the condition-based range.
- Flag a sunken or rocking paver as soon as it's noticed rather than waiting; a small, early releveling costs a fraction of rebuilding a larger failed section later.
- Ask whether dry sand, which costs less upfront, is enough for a shaded, low-traffic area where polymeric sand's washout resistance matters less.
What a paver sealing quote should spell out
A per-square-foot number by itself doesn't say whether a quote covers cleaning alone or the full clean, re-sand and seal visit. Ask every bidder for the same specifics so two quotes describe the same job:
- The order of operations in writing: releveling first if needed, then cleaning, then sand, then sealer, never sealer applied before the surface is fully dry
- Sand type named specifically, dry or polymeric, not a generic line item that just says 're-sand'
- Sealer finish, wet-look or natural, with a sample on a small test area before the whole surface is committed
- Square footage measured on site, not estimated from a driveway's listed width alone
- Whether a minimum job fee applies, and what square footage it covers
Related reading
For the full service scope, see our paver sealing and restoration page, which covers the order of steps and why releveling comes first. Polymeric sand vs. regular joint sand and wet-look vs. natural-finish sealer go through the material choices. Why pavers sink in Florida and stopping mold and algae on pavers cover the causes behind the two most common calls, and ants and weeds between pavers rounds out the maintenance picture. The cost guide hub has current pricing for every other service we offer.
Frequently asked questions
How much does it cost to seal pavers?
Cleaning, re-sanding and sealing an existing paver surface in Florida runs $1.50–$3.25 per square foot, with most jobs landing nearer $1.75–$2.75. Central Florida contractor pricing for 2026 lines up closely, with most homeowners paying $750 to $2,500 for a 500 to 1,000 square foot surface.
Is sealing pavers worth the money?
Usually, measured against the cost of letting a loose joint turn into a sunken paver. Sealing itself is optional under the paver industry's own spec, but it locks joint sand in place and slows staining and fading. Paver releveling and repair run $7 to $30 per square foot once a surface has actually failed, well above the $1.50 to $3.25 per square foot a routine sealing visit costs.
Does pressure washing alone cost less than a full clean-and-seal?
Yes, considerably. Pressure washing by itself, with no re-sanding or sealer coat, runs $0.35 to $0.80 per square foot nationally, against $1.50 to $3.25 for the combined service. Washing alone strips algae and grime but does nothing for joint sand that's already washed out or a sealer coat that's worn through.
How much more does releveling sunken pavers add to a sealing visit?
Releveling a larger sunken area runs roughly $6 to $12 per square foot, and swapping individual stones runs $8 to $20 per unit, added on top of the base cleaning and sealing price rather than replacing it. A small handful of sunken pavers near a drain or a pool skimmer typically costs far less to fix than letting the problem spread across a wider section.
Is there a minimum job fee for paver sealing in Florida?
Often, yes. A South Florida contractor publishes a $1,000 minimum regardless of square footage, and Central Florida pricing shows the same pattern, with small jobs under 500 square feet running toward the higher end of the per-square-foot range. Bundling a driveway, patio and walkway into one visit spreads a minimum fee across more square footage.
Does a pool deck cost more to seal than a driveway?
Slightly, yes, in published Central Florida pricing: roughly $1.75 to $3.00 per square foot for a pool deck against $1.50 to $2.50 for a driveway. Chlorine, splash and more frequent water contact wear a sealer coat faster near the water, which is the main reason the rate runs a little higher there.
Why do two Florida paver sealing quotes for the same job differ so much?
They often describe different scopes. One bid may include releveling a few sunken pavers, polymeric sand and a wet-look sealer; another may quote a basic clean-and-seal with dry sand and skip any sunken units entirely. Asking each bidder to list sand type, sealer type and whether releveling is included is the only reliable way to compare totals.
Ready for a price on your project?
Request a free estimate
Tell us about the project and we'll call to set up a free site visit.